Heatshrink sleeving to cover the shaft of our Anti-Pinch Pin, to protect valuable items that are being secured.
Beware: You still need to handle the Pin and any chains carefully as this will only provide a certain amount of protection.
This is a single length of sleeving, only. The push-on plastic cap is available separately.
It is necessary to cut this to length and shrink this onto the Pin and, for that, ideally a hot air gun is required or otherwise a powerful hairdrier or careful use of steam from a kettle. Take care not to suffer burns!
Although this is flame retardant, you should keep it clear of any hot items and especially hot exhausts or other engine parts.
**Please note that current stocks of the separate Anti-Pinch Pin Washer will not slide over heatshrink. A new batch of washers is in manufacture with a 26mm hole that will allow it to slide over heatshrink.**